Lf2 Pn100 Low Temperature Manual Forged/Forging Three Pieces Ball Valve

Lf2 Pn100 Low Temperature Manual Forged/Forging Three Pieces Ball Valve

1. Pressure rating: 150LB、300LB、600LB、900LB.
2. Nominal diameter: 15-1200 mm (1 / 2-36 ").
3. Connection type: flange type, welding type, thread etc.
4. Valve material: LCB, LC3, CF8,CF8M,CF3,CF3M.
5. Applicable media: liquefied natural gas, ethylene, propylene, etc.
6. Driving mode: manual, bevel gear drive, electric.

Product Details

We continue to undertake new projects in the technical field, accumulate rich experience, and lay a technical foundation for the research and development of new series of ball valve with drain port, 2 piece ball valve, concentric design butterfly valve. We uphold the business philosophy of 'Quality is a responsibility' and look forward to working with you. We always adhere to people-oriented, deeply concerned about the safety and health of employees, and strictly follow relevant laws, regulations and standards to implement the main responsibility of the enterprise.

【Product Introduction】

The Cryogenic Ball valve suitable for medium temperature of - 40 ℃ ~ - 196 ℃。This ball valve adopts strict manufacturing process and special equipment to carry out strict quality control on the processing of parts. After special low-temperature treatment, the rough machined parts are placed in the cooling medium for several hours (2-6 hours) to release the stress, ensure the low-temperature performance of the material, and ensure the finishing size, so as to prevent the leakage caused by the deformation caused by the temperature change when the valve is in low-temperature condition.


Valve Features

Type : Trunnion Ball Valve

Connecting : Flanged end , RF

A182 F316 Forged steel

Full bore, 3piece body construct

Extended Stem design

Drive : Pneumatic actuator

Suitable Temperature : -29°C ~ -65°C

Suitable Presure: 2.0Mpa/150LB

For tight shut off

Standard : API6D, API608

Packing: Plywooden case

Certificate : EN 3.1 certificate


cryogenic-ball-valve06331319433微信图片_20191206131653


Cryogenic Treatment Way

The cryogenic treatment of cryogenic ball valves shall be applied to the main components of any cryogenic valves at -101 ° C and below, or as required by the technical agreement.And improve the reliability of the valve under low temperature conditions;

1、Before the roughing is completed, "cryogenic treatment" is carried out in a low temperature liquid nitrogen tank that is 100% immersed in -196 °C. 

2、Immerse the parts in a liquid nitrogen tank for adequate cooling. 

3、When the part temperature reaches -196 ° C, keep the temperature for 1-2 hours (or according to the requirements of the corresponding technical agreement), then remove the box and naturally heat to room temperature.

4、The purpose of "cryogenic treatment" is to eliminate the martensite transformation of the Cryogenic Ball Valve material and the sufficient shrinkage deformation of the material at ultra-low temperatures.

5、Thereby eliminating the potential hazards affecting the dimensional accuracy of the cryogenic valve seal. 


We will provide customers with high-quality Lf2 Pn100 Low Temperature Manual Forged/Forging Three Pieces Ball Valve and satisfactory services with honest and trustworthy, convenient and efficient operation methods and strict management. We are willing to provide you with 100% satisfactory service with excellent quality, advanced technology, cost-effective products, and a professional team. We adhere to the quality-oriented, efficiency first, continuous improvement, people-oriented management philosophy.

Inquiry

You Might Also Like